Ender-5 Plus will not start after Firmware update
-
Updated the firmware, and the unit will not longer turn on, it will have at the startup screen loading bar.
-
Dear @Shmoolord,
As there is a ZIP document that can't upload in this forum, so I send you an email. Please check.
-
There is a firmware too big to upload, I have reset the forum, and try it tomorrow. Thank you.
-
Dear @Shmoolord,
Please refer to the tutorial to refresh the motherboard firmware:
https://www.youtube.com/watch?v=31DKYpykQ6U&feature=youtu.be
Ender-5PlusBLTouch_0904_V1.70.1 BL.hex