Printing bed problems



  • I have four 3-D printers and one of them is a 10s pro v2.
    My problem has always been getting the print stick to the bed. Currently I have a Dobstfy magnetic surface that I run at 105 C. I clean it with alcohol between prints but even that is not working. I have used about every type of bed out there with the same result. I’m printing tough pla I believe if I could get the product to stick, I could work on the quality of my prints.
    Any suggestions would be appreciated.
    Thank you
    JHA


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.