Ender 3 V2 - X belt tensioner fix by CHEP Filament Friday!
Credit to CHEP for this genius simple fix to get the X belt tensioner tight. Creality should add this solution to their kit with addendum sheet with current fixes along the way to reduce unnecessary support hits.
The 2 screws / bolts share the same mounting hole and bottom out to each other. He put a 1mm washer on the back side screw to back it out so the 2 screws don't hit each other.
Thank you CHEP!
PS. Hope this also helps the X BELT also being offcenter (at right side pulley bearing) which may rub on aluminum extrusion profile? Cannot figure out if this can be adjusted?
As for the x belt right of printhead, if belt off center of pulley being towards front under profile... solution may be to move right end of x belt in its slot back some to center more on pulley to prevent rubbing under x axis brace aluminum profile.
Hi Tim, thanks for your feedback and suggestions. I will transfer these suggestions to our team, if any news will update here. Thank you.