Marlin source code for CR-200B (mainboard V 4.2.5)



  • Hello,

    I'm looking for the source code of the firmware for my CR-200B. It is running Marlin, so it should be available somewhere.

    If this is not available, a pin mapping and config file would be welcome - from what I've gathered, it uses similar hardware to the CR-6 SE, but it uses a slightly different mainboard (v 4.2.5 vs v4.2.2 or v4.2.7), so I have the vain hope that the CR-6 community firmware can be made to work.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.