Creality v2.2 silent not triggering mosfet for bed heating.



  • Strange problem with my CR-10 with a Creality v2.2 silent board.
    This morning I noticed my carriage did not return to the home position after the print was done.
    I disengaged steppers and removed the finished print.
    Now I want to start my next print and I notice that the bed is not heating anymore.
    check with the multimeter if I was getting 12v out of the mosfet but it wasnt active.
    Checked the pinout on the board. set the bed heating to 50 and noticed that the board was not triggering the port to trigger the misfet to heat the bed.
    Printer worked fine before so I dont suspect a firmware issue.
    Is the board broken? or is there another fix?


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.