BL Touch too high?



  • I just installed a BL Touch on my Ender 3-V2 3D.
    It seems to work, it goes around and touches the bed in various places.
    If I do auto home it goes to roughly the middle of the plate, touches and comes up twice. According to the instructions I read, at this point you adjust your Z offset and until a piece of paper just catches under the nozzle (Just like manually leveling the bed).
    Problem is, the nozzle is very far from the bed. I even went -10.00 and it was still a mile away. I raised my bed up as high as it would go and manually leveled it, but it's still too far away.
    All I can think of is the BL sensor is mounted too low, but I can only see one way to mount it.
    Any help would be great.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.