BL Touch Upgrade on CR10S Pro



  • Hello. I am descending into madness trying to get this to work. I bought a BL Touch from Creality and did all the steps to install it on my CR-10S Pro. I noticed when I turn on the printer the screen stays off UNLESS I unplug the Brown wire from the BL Touch. I switched the wire on the motherboard like the directions say to but I can't figure out why it won't work.

    My BL Touch harness is the Creality one. Blue, Red, Yellow, black and white. Black and white is a no brainer. I have orange, brown and red on my wire extension. So I have connected brown/blue orange/yellow and red/red and it still won't work. Anything I could be missing? I have the 2.4 motherboard.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.