Crtouch issues



  • Can anyone help me troubleshoot my cr touch?

    Ender 3 v2

    I have the firmware updated.

    I updated my gcode on the slicer to add g29.

    I manually leveled the bed.

    I set my z step with paper.

    I ran a bed level from the settings, then when it starts the print it ran another, so I assume the gcode change took.

    And this is what I get when I run the print test. Super thick on the right side, good thickness but uneven in the middle, and too tight and clicking my extruder on the left.

    A properly running touch sensor should sort all that out, right? Or am I misunderstanding what this thing is supposed to do? What am I missing?

    alt text


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.