3D prints do not hang on the buildplate



  • when i print with the printer (halot one) the print fails part of the print sticks to the release film of the resin reservoir. what can i do about this? am i using wrong settings? or the wrong resin (Anycubic Plant-based UV Resin)?



  • hi, @Quinten-qp you can try the following methods

    1. on the basis of the original exposure number, , increase by 2s as a unit, the maximum can be increased to about 100; increase the first layer exposure layer by 1 unit, the maximum can be10 layers
    2. slice the file again, and add the support to increase the contact with the printing platform
    3. replace the resin

Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.