3D prints do not hang on the buildplate



  • when i print with the printer (halot one) the print fails part of the print sticks to the release film of the resin reservoir. what can i do about this? am i using wrong settings? or the wrong resin (Anycubic Plant-based UV Resin)?



  • hi, @Quinten-qp you can try the following methods

    1. on the basis of the original exposure number, , increase by 2s as a unit, the maximum can be increased to about 100; increase the first layer exposure layer by 1 unit, the maximum can be10 layers
    2. slice the file again, and add the support to increase the contact with the printing platform
    3. replace the resin

Log in to reply