not printing, a beginner on an ender 3
Hello, I was printing quite well, for the bed leveling for the first test piece, a pig. This piglet had a few strings between its ears so I began a set up using a retraction setting tower and a temperature tower. After using the retraction tower the nozzle stopped working. During it one of the settings must have been too high and the PLA stopped flowing. It has not worked since. If I clear the nozzle then the PLA starts flowing from the end but when I begin to print it stops. So i am wondering if somewhere there is a default retraction setting and mine is now too high? I am a beginner so any help please?
Gracy last edited by Gracy
Hi, @Carol You can refer to this post.