Silent board upgrade



  • I just upgraded my board to a Silent board in my Ender 5. It now moves amazingly quite...kinda ghost like in everyway. In fact it doesn't print anything because the E stepper is running in reverse and instead of feeding filament to the nozzle, it unloads it???? Not quite sure what went wrong there as there is no way to reverse the leads. There are no settings in the slicer that I can see where you can change it. Love the quiet, but will have to re-install my original board until this gets figured out. HELP



  • @Ron
    Dear
    Please check whether all motor wiring is correct, please provide photos of the motherboard and motor terminal wiring. Heat the nozzle to 200 degrees and move it alone. Whether the E motor rotates normally


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.