Ender 3 v2 problems
-
Everytime I try to print, it auto homes like normal, then it just says it's complete and ends the print. I haven't been able to print once. Please help, thank you! https://streamable.com/a7ek7q here is a video of what is happening, after autohome the progress bar goes to 100% then says completed but it never prints.
-
@dylankhicks
hi,
can you confirm that is not from your slicer by checking the gcode (or by using a reference gcode confirmed good).. if slicer/gcode are confirmed good, the firmware can be suspected (and reflashed with an other version than the actual one for comparison)..
-
@dylankhicks better get rid of it and buy a decent printer e.g. Ultimaker C5
-
@Yolanda Better get rid of it, and buy a descent printer e.g. Ultimaker C5
-
@dylankhicks hi,try to flash the firmware again, and then print the following files for testing xyzCalibration.gcode
If the issue still exists, please replace with a new mainboard.