Ender 3 V2 Power Loss Resume

  • Is it possible after a power loss for the print head to move up slightly and return to home like the Prusa MK3S?

    Via firmware or is this something that must be hardware related (capable) with the power supply and capacitors?

    Doesn't seem like much of a resume after power loss, if the print head nozzle still leaks a little filament, then fuses to the layer it was on during power loss. Then after power resume, it may pull the printed model in progress off of the bed? And that's if it didn't already pop off after the model/bed cooled?


  • Dear Tim, After power off, the print head stays at the position it was at the moment before power off. It will not return to home like the Prusa MK3S.

Log in to reply