Issue with printing ender 3 filament guide, end clip frail and brittle



  • Hi I am trying to print out a filament guide from thingeeverse. The guide itself came out fine but as can be seen from the attached pic the end connector which attaches to the frame the lugs are all kind of melted and crumbly. I am using PLA filament and using the settings in cura recommended by the filament manufacturer.
    all my other prints seem ok except for the lugs on this end clip (in the photo the end clip is attached to the arm.

    Any help would be appreciated.

    David

    ![0_1633297651789_3d print.jpg](Uploading 100%)


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.