Ender 6 will not home or allow z axis adjustment
New Ender 6 running firmware VER 184.108.40.206 will not home correctly. Z movement only move in one direction
Same problem, worked up to 18-25 grid then froze...no matter what firmware (220.127.116.11 endstop/Bltouch 18.104.22.168) and same freezing problem on auto leveling press...2 and half months now trying to figure out whats wrong!
- brush back to the original firmware, change the name of the firmware, any name, just does not appear in Chinese.
2.If it still does not work, check whether the Z-axis limit switch can work, measure the voltage at the interface of the Z-axis limit switch on the motherboard.