Ender 6 will not home or allow z axis adjustment



  • New Ender 6 running firmware VER 1.0.4.9 will not home correctly. Z movement only move in one direction



  • Same problem, worked up to 18-25 grid then froze...no matter what firmware (1.0.4.9 endstop/Bltouch 1.0.4.9) and same freezing problem on auto leveling press...2 and half months now trying to figure out whats wrong!



  • Dear @Cmute

    1. brush back to the original firmware, change the name of the firmware, any name, just does not appear in Chinese.

    2.If it still does not work, check whether the Z-axis limit switch can work, measure the voltage at the interface of the Z-axis limit switch on the motherboard.


Log in to reply