Runaway Heated bed temp!



  • Greetings!
    I recentley upgraded my Ender 3, to the EEXL, with the new 4.2.7 motherboard and the creality touchscreen.
    I am having trouble with controlling the heated bed temperature. As soon as as I power it up, the bed starts heating up, and goes to 70+C. I have tried adjusting in Cura, Pronterface and the touchscreen, with no luck. I need help!



  • @jmauser I have the same issue with my Ender 5 Plus and cant figure it out. any help would be appreciated as well



  • You might look at your temperature sensor. If not that then the controller board. But my money is on the sensor or its wires


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.