Ender 5 Pro, layers of print model will not stick together. Help!



  • Have others had this issue?



  • Hi,
    I just joined this forum, and I'm new to 3D printing. I have been using Comgrow PLA White and Black filament without getting a good print. The raft or brims print fine, and the first layer looks OK. Then, the following verticle layers are attached at the corners but detached from the Infill in between. A calibration cube or box has a good core, but I can peel off the outer layer.
    Any advice would be appreciated.
    BCC


Log in to reply