Ender 3 FW/CRTouch

  • Hello,

    I just installed CRtouch on my Ender 3, however, the official firmware with CR Touch does not work - steppers are not moving, just making noise.

    I installed 2.0.1. marlin with BLTouch support, however when printing, while doing G29 before.print, after touching all 9 points, it goes way down on the right side, and my silicone nozzle cover scrapes right side of print bed.

    Any idea why is it doing that? And why the official firmware is not working? Thank you

Log in to reply