CR-X Print does not stay adhered to build plate.



  • Hello! I am new to Creality printers and just setup a CR-X. s The printer is calibrated to the directions listed within the user guide. I am using PLA with temp setting of 200C and using the Creality calibration of .2mm. Currently, I am printing Benchy as my test print. The prints start out great and adhere to the plate. When the build begins the roof for the wheel house, the entire build moves on the build plate. Any suggestions for a noob?



  • @Mr-Keller

    Hello, I don't know if it's worth digging up this post but, I noticed that the energy saving option (bed heating cut off depending on the height of the print) if activated was systematically unhooking my print.


Log in to reply