Ender 3 V2 Bed not heating and burning smell.

  • Hi all,

    Ive had my V2 for a couple of months now and when i turned it on today the bed began to heat up but then i noticed a burning smell and the temperature stayed the same (about 40 degrees) then began to drop. I immediately turned it off and the smell disippated. I turned it back on and now the bed doesnt heat at all. Everything else works fine. The smell appeared to come from the compartment with all the wiring / board next to the drawer.

    With the printer only being 2 months old and hopefully under warranty, I have contacted Creality to discuss this and I am waiting a response. I wondered if anyone else has had this problem and what the possible causes / fixes are?

    Any advice would be appreciated.

    Thanks in advance,

Log in to reply