Get my Ender 6 today and need some Informations

  • Hello,
    i am happy here and get my Ender 6 Today... i read a lot on that Problems some had at Out of the Box and will be 100% do that right today.

    • i not found Driver for Ender 6 that i can use Octoprint for Calibration and PID
    • is it better use TM Firmware and if it so can someone send a link i not sure get the right version and will not do some stupid Updates 🙂

    If some important notes to start with the Ender 6 i will happy if someone had a list an all to do. Found a lot but not sure all is the best way get a stable fast Printer.

    Sorry for my bad english its not my favourite and regards from Switzerland

Log in to reply