CR-10 v2 controller hangs after preheat cycle



  • I'm having an issue with my controller (firmware, I assume).
    If I run preheat or start a build, which obviously preheats, the controller freezes up after displaying "Heating done", and you can hear something change, like the fans changing speed.
    The control knob is unresponsive (dial and push); I have to shut down.
    I have also tried unplugging to reset.

    Anybody experience this / how to fix? I think there's a "reset" control (like a cellphone) somewhere; I will try that if I can find it.
    Thanks.


Log in to reply