Model starts printing above bed after several layers of support have printed



  • Hi all,

    I wonder if anyone could help me with this problem. I'm printing a model that needs minimal support. I have tried this model with and without support. It prints fine without, squishes the first layer nicely. But if I try and add support, it will print many layers of the support (in Cura and Simplify, I tried them both) then go on to print the model at the height it left off at above the bed. Only after adding support does this happen. I've been slicing in Cura. I have a CR10 S5
    I've used the tick box that says drop the support to the bed, & I've tried some other settings like Printing all at once and one at a time. The results are always the same.

    thanks in advance!


Log in to reply