Ender 3 & CR Touch leveling problems
I've installed my CR Touch and I'm having nothing but problems getting the bed level.
I'm setup for UBL with a 10x10 grid. My M851 is X-45.70 Y-5.86 Z-0.52.
I run the following sequence.
G29 P3 ;First column fill
The visual output is easyer to see the problem.
There is no way my bed is shaped like that. Plus if I move to one of the channels and do a G29 P4 to adjust it, it is always off. Probing multiple places doesn't give me a consistent offset, so I can't conclude that my Probe Offset is wrong.
Is there a test I can do on the CR Touch to validate it is working right?
@mtwombley Youtube will help