Ender 3V2 + BL touch = disaster



  • My printer arrived without the BL touch so I set it up anyway, and ran a couple of prints that came out well even with the glass top upside down (shiny side up).

    Then I got the BL touch, installed the latest firmware an nothing has gone right ever since. I just tried to use it without the touch and it refuses to work. I can't find up to date firmware that does not require it and I am getting fed up!

    I have just started a a print and the front is thick on the first layers and the back thin, like the bed slants one way or the other, so what was this piece of junk for again?


Log in to reply