CR Touch on ender 3 32bit 4.2.7 board not auto leveling



  • I put a cr touch on my ender 3 with the 32 bit v 4.2.7 board. I used the marlin2.0.6 CR touch firm ware from creality website. It will auto home and allow me to do a z-offset. But when I tell it auto level the bed, it goes to the first point, takes a measurement, then stops and turns off the auto level. I get the same result with the original z stop disconnected, and when I have it connected and lowered below where the cr touch z stop is. Please advise how to get the leveling to work


Log in to reply