Ender 3v2 CR Touch
-
I just purchased a CR Touch for an Ender 3v2. I have downloaded different firmware. Not sure which one I need. There is one under CR firmware, one under Ender firmware. I've loaded a few different ones. With everyone of them, the CR Touch turns purple, moves around, goes the center, pops up and down a few times, then blinks red and does nothing else. The screen continuously says "bed leveling please wait". Please help. @admin
-
Hello? Is anyone from Creality monitoring these forums?? @TeacherThomas did anyone get back to you on this? I'm on my 3rd week with no replies on the forums or from cs@creality.com. I am starting to think I made a mistake in purchasing a Creality printer.
-
Same here, but my z-axis won't go down, just up, then stops. I posted in the "accessories" part of the forums. @admin
-
Same problem @admin