CR-6 SE Keeps driving into bed on auto level



  • Re: CR-6 SE autolevel keeps pressing printhead in the middle

    This issue randomly would happen on my CR-6 se and now has become constant. I've replaced the z axis sensor, the strain gauge, and the hot end breakout board. The blue light comes on, on the breakout board when slight pressure is is on the nozzle. Yet still does not engage on auto level and continues to drive into the board.

    I'm a step away from replacing the motherboard, (currently the V4.5.2) but everything I've been reading doesn't necessarily fix it.


Log in to reply