What am I doing wrong? Doesn't seem to stick to the build plate...

  • Newb - sorry - if this is the wrong place please direct me.

    E3 S1 Pro. Trying to print the handle example using the supplied filament.
    Doesn't seem to stick correctly.
    Research tells me:
    Re-level - done between every attempt.
    Bed not hot enough. Raised temp to 70 and 80. No change.
    You need something to make it stick - got Magigoo and applied.

    So, what can you tell from the picture? Any feedback appreciated.


  • @PaulMacFarlane

    Printing the first layer too high. Reduce the Z offset until it starts to stick.

Log in to reply