Firmware selecting correct version

  • HI,
    I have Ender 3 Pro.
    The motherboard shows 4.2.2 as Creality version.,
    The Printer shows as

    • Marlin
    • Ver 1.0.1
    • 2020-04-25

    Is there a firmware update in .hex form (trying to use Creality 5 to update firmware)
    Where is it to be found?


  • Just found out that there are far more options on this firmware. The only thing is NO instructions on the file
    GD_Ender-3 Pro_HW_V4.2.2_SW_V2.0.8.2_20211009.bin
    There are quite a few different avenues to travel down and could do with some guidance, preferably a .pdf or .doc file.
    Anyone help please

  • Hi
    Worked as expected.
    Only one delay and that was finding the English from a Chinese menu.

    Regards and thanks again

  • Hi Anton,
    Thanks for the input, I'll get to the page in a few minutes.

  • The 4.2.2. board is a 32bits version using .bin files. The .hex files are for the 8bits boards.
    You can find the bin files at the Creality support download section.

Log in to reply