cr-6 is stuck on "Auto home, please wait for minutes"

  • So last evening I finally got the cr-6, everything was going fine until I turned it on. I then pressed Prepare>move>crosshair button, which I think it's supposed to put the nozzle in the "home" position, it then went to "Auto home, please wait for minutes" and I did just that. Except the reality was that I waited for an hour and nothing happened. I turned it off and tried it again... same results. I then tried to do the auto-leveling system... it worked the first time, but every other time I tried it, "Auto home, please wait for minutes"

    Please help me. I've been waiting for this printer since May and I can't take this kind of stress in my life.
    I don't know what to do.

  • For auto-leveling, try pre-heating first. It sounds backwards, but that's what I did and it worked on mine at least.

Log in to reply