CURA Printer Profile: CR-10 V3
-
I recently purchase a CR-10 V3 & BL Touch based on the recommendations of other people. I was very frustrated tying to find the BL Touch firmware that goes with this model. Ended up using the firmware for the V2 model. I certainly hope this was correct.
My question is what profile do I use in the CURA slicer; there is NOT one for CR-10 V3. Someone suggested using the CR-10S profile.
Does anyone have a working profile for the CR-10 V3 that I could experiment with?
Thanks!
-
Dear @Muff_Herder
CR-10 V3 bltouch firmware program:
CR-10 V3TF1.1.6.0BLTouchV3.1PowerLossContinueFilamentCheckEnglishandChinese382.14.hex- Select CR-10 V2 for the machine in the slicing software.