Ender 3 V2 - BLTouch Port info
-
I see that the bltouch firmware is back up, wanted to know if there is any source where I could find more instruction about how to use the reserved bltouch port on the board, especially the wiring. There are a lot of instructions online but none of them are updated for the Ender 3 V2 and instead ask people to use z limit port.
-
Load the latest Marlin firmware and your good to go. You can compile to use the zswitch port or the bltouch port. Wiring is fairly simple.
-
me too. This thread needs to gain more traction.
-
@admin waiting for instructions