Just got a CR-6



  • This post is deleted!


  • Well it smoked, and the parts that burned on the mobo are U9 near the USB port and Fuse F3.
    This is bad USB circuit, as when I got close to the shield on the USB and plugged in my PC USB cable, I noticed sparks.
    Then tried again no sparks, 28 hours later I was going to print via USB and then it smoked. This can be fixed easily with a replacement mobo.
    and redesign of the board USB.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.