Ender 3 V2 black display
-
My display isn't booting up. I've checked the connectors both to the board and the display, the memory card has been formatted to FAT32, D_win has been reinstalled as well, lastest bl touch compatible Creality original .bin firmware has been reinstalled and named differently and less than 20 characters. Also tried Smith3D latest firmware V2.0.X.13. When I boot up the firmware in the display and power on, I get a blue flash then a red/orange display. With the memory card out and powered up, fans run during startup like normal and bl touch clicks like normal. The screen is "on "(blacklight) but other than that the actual screen is black.
-
@admin
We have done all that was in the instructions and the screen is still black. Could the SD card be bad? It was working fine then just stopped.
-
@Alenmche4 having the same issue
-
Dear @Alenmche4
Please do not refresh the non-our company's firmware, otherwise, the warranty will be lost;- Refresh the motherboard firmware tutorial: https://www.youtube.com/watch?v=AKIfwPgN0qs&feature=youtu.be
- Refresh the display firmware tutorial, format the sd card, then copy the display firmware to the sd card, then insert the sd card into the card slot of the display, then the display will automatically refresh the firmware, and the display will display orange That is to refresh successfully https://www.youtube.com/watch?v=Jswzrh2_ekk
DWIN_SET.zip
Ender-3 V2-Marlin-2.0.1 - V1.0.1-2.binAfter refreshing the above motherboard firmware and display firmware, if it can boot normally, please refer to this video to refresh the bl touch firmware: https://www.youtube.com/watch?v=lI9ISEPPX0w
Ender-3 V2-Marlin-2.0.1 - BLTouch.bin