Has anyone been able to build the source?

  • Hello, I am wondering if anyone has been able to build the source code and run it.

    I have been looking at this bed leveling issue and was wondering if the information from the link below when implemented would solve our problems.


    It might be worth a shot. If anyone can point me on how to build the source Id be willing to give it a shot and test it.



  • Yes I have, without serious issues. The compiles code runs just fine.

    I needed to do this, because I broke my abl sensor. I modified the code to use the z endstop now in stead of the abl sensor to home the printer and I manually configure the Mesh.

    So far so good...


Log in to reply