Problems with my prints, ender 3 pro
I'm a new owner of creality ender 3 pro. I started printing som pieces but I hat the same proble two times.
I send you two photos of the problem
- Follow the instructions to re-level the platform/leveling after observing the first layer out of the degree of extrusion in the printing can be an appropriate fine adjustment of the hotbed leveling nut
- hotbed temperature PLA material set to 60 ° (40 ° too low)
- Add the base when the model is sliced
the bed leveling Tutorial: https://youtu.be/GeuvoCZY4CI
It looks like you're not getting bottom layer adhesion, I also recommend leveling your build plate. This video is very useful:
Try leveling the bed or using the raft option when printing, i think that is bad adhesion. I had the same problem so i changed the magnetic bed for a 3mm glass y worked just fine!
I'm pretty much getting the same thing with an initial print. Any suggestions would be appreciated.