CR-6 SE NEW FIRMWARE UPDATE

Starkiller

On Youtube there are two different updates shown. One on the front of the printer and one when you open it and insert a microsd into the board underneath the touchscreen.
Can you tell which files go into which section?
thanks

Bizkozine

it would be nice if the firmware can read more than 5 pages of files, it's kind of annoying to look for old files when it can only read files up to 5 pages

LukCr6

I'm running V1.0.3.6 still having two annoying issues:

The nosle scratches on the print bed if i cancel the print while printing the first layer
The bed leveling data get lost on a power cycle, so I need to repeat the bed leveling before every print

ncbob

@pro_info That's a bummer, that's the biggest issue I had with the firmware, that and M600 not working.

pro_info

@ncbob No

/**
 * EEPROM
 *
 * Persistent storage to preserve configurable settings across reboots.
 *
 *   M500 - Store settings to EEPROM.
 *   M501 - Read settings from EEPROM. (i.e., Throw away unsaved changes)
 *   M502 - Revert settings to "factory" defaults. (Follow with M500 to init the EEPROM.)
 */
#define EEPROM_SETTINGS     // Persistent storage with M500 and M501
//#define DISABLE_M503        // Saves ~2700 bytes of PROGMEM. Disable for release!
// #define EEPROM_CHITCHAT       // Give feedback on EEPROM commands. Disable to save PROGMEM.
#if ENABLED(EEPROM_SETTINGS)
  //#define EEPROM_AUTO_INIT  // Init EEPROM automatically on any errors.
#endif

Yes, but when I do an M500, it doesn't work for me.

gromar88

The archive contains of two folders: "32bit mainboard firmware" and "32bit screen firmware". Should I copy files from each folder and run them separatly from SD card or should I place all files all together and run them at the same time? Would be nice to have specific instruction. Thank you in advance for respond.

ncbob

Is the EEPROM enabled in this version?

Daverobbo1904

@admin any idea when that will be please
thank you

admin

Dear @Daverobbo1904

As I know, this firmware is confirmed before your question, then I don't think it has been added in. But I have sent your suggestion to our engineer and will confirm if it will be added to the next firmware.

Daverobbo1904

@admin thank you for that can you confirm that the M600 command has been added