Stops printing - “ check filament”
I got an issue with my CR-6 SE. I printed over night and it stoped with prompting “check filament load” or something. I was able to just resume, but I was hoping for a finished print in the morning. I just had put a new PLA role on. Is there anyway to avoid this?
Maybe the sensor board is loose. I had the same issue and after troubleshooting I came over this video to help fix the issue
@neok23 Dear, there have a few problems may cause the pause when printing, such as power failure, material interruption and material interruption detection switch failure. Please check whether the filament sensor switch works normally.
You can also unplug the filament sensor line on the motherboard to try printing.