Stringing & Ball Clogs on 3D Print



  • Hi,

    I am very new to 3D printing and do not possess so much knowledge on the matter. I have an Ender 3 and while trying to print something I have too many strings from the filament (thin like hair strings) and also many ball clogs of filament on the bed.

    The settings I use, are the standard from Cura 4.7.1 for Standard Quality, and due to PETG filament, the only changes I have done is that Nozzle Temp is 240 and Bed at 105, no cooling, and retraction is enabled.

    For some weird reason, Lower Bed Temps do not work, as the filament does not stick on the Bed.

    Bed is Magnetic btw.

    Picture shows example of what I mean, in a Bed Level Test print.

    Any help would be much appreciated and I thank you in advance.

    Kind Regards to everyone.
    ![0_1603109160599_IMG_20201019_144734.jpg](Uploading 5%)


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.