CR-6 SE, definitely think i should have ordered another Ender 3 Pro

  • Wow for how much this printer was with shipping. it definitely has not lived up to my expectations. Printed great for a few weeks, now it has had the switch fail, filament sensor going off during long prints, pause and print never lines up in the same place.

    Is a refund possible?

  • @NeoOiler Dear, sorry for your concern, you may check with following steps .

    1. Switch failure, please refer to this video to check:
    2. There have a few problems may stop printing, such as power failure, broken material, and broken material detection switch failure. Please check whether the broken material detection switch is working normally.

Log in to reply