CREALITY CR10S
-
The motor on my filament feeder is not working. I installed a new one and it still is not working. Any suggestions?
-
Dear @LEYEAGER
Will you please share the video for your testing? Our engineer needs it for analytics. Thank you
-
where is the mainboard extrusion motor interface?
-
New line and new motor. Still not working. Checked everything else you said in reference to switches and all are working
-
@LEYEAGER 1. Please check the extrusion motor cable.
2. Use the substitution method to interchange the X and E motor wiring, make sure that the limit switch is not pressed down, and confirm that the line is normal and whether it works normally after changing the line.
3. Check the X motor working normally after changing the line.
3. Measure whether there is output voltage at the mainboard extrusion motor interface.