Bed wont stop heating / Bed heat thermal run away
-
I have received CR6SE from backing on kickstarter. After simple assembly the first time i turn the printer on to do bed level i notice the bed gets warm immediately, power cycling the printer a few times there is no way to control it the bed gets hot and doesn't stop getting hot, i've let it peak out at 120deg before turning it off in a panic.
Picture of the board
I have check and re-checked the basics unplugging and reseating every cable/plug.Video of the issue
https://streamable.com/ei04gtBacker Number 5062
Also i think these posts are related
https://forum.creality.com/post/976
https://forum.creality.com/post/2729
https://forum.creality.com/post/2593
https://forum.creality.com/post/972