Ender 3 V2 Changes infill



  • Hii,
    First of all, I love the ender 3 V2.

    But is seams that when I start a new print job after a other one without removing the SD cart (there are already multiple .gcode's on the cart), the printer chances the infill %.
    I'm sure I put it on 5 or 10 %, but then it prints 15 or 20, I'm not sure.

    Could this be a system error? Or is it suppose to do that?

    There is always the small possibility of human error on my part.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.