Received my box today. Set up was a breeze. Using is a bit clunky. Seriously lacking the ability to upload models directly from PC. The only work around I've found it to email it to myself, open it on my phone and proceed from there. Any have a better way, please share.
357bob
@357bob
Best posts made by 357bob
-
PC access
-
RE: Can we get some instructions for Motherboard and Screen Firmware installation?
@ibgeek Amen! I've been looking a long time with no success.
Latest posts made by 357bob
-
RE: PC access
@guang11cheng I go to the site and can view models but can't see a way to upload. Any instructions?
-
RE: Can we get some instructions for Motherboard and Screen Firmware installation?
@ibgeek Amen! I've been looking a long time with no success.
-
PC access
Received my box today. Set up was a breeze. Using is a bit clunky. Seriously lacking the ability to upload models directly from PC. The only work around I've found it to email it to myself, open it on my phone and proceed from there. Any have a better way, please share.
-
Change filament menu option Ender 3
I recently upgraded to the silent board v1.1.5 and it no longer has the "change filament" menu option during printing. I used it quite often and have used the pause at height method as well. Problem with pause at height is when manually removing and inserting filament, more often than not something moves and the layers shift. Any way to get this option back? I'll probably go back to the old board although my reason for changing was the thermal overrun protection.
-
Change filament menu option gone
I recently upgraded my Ender 3 to the newer silent mother board. The previous firmware version had an option during printing under tune to "change filament".
It's gone now. I used it often and would like it back. Any ideas?