I recently bought the Ender 3 and was chugging along with the set up and started making my first prints. As I was starting on a new print I noticed the bed mat was moving a bit so I stopped the print and put the included clips onto the mat. I didn't think about the placement of one of the clips (back left corner) and upon starting a new print the clip came into contact with something causing a spark. I turned the machine off real quick, checked everything, and upon turning it on again I get a blue screen without any text. I spent about 30 minutes going over everything again, yet I'm still getting the blue screen.
I checked all the connections and they're good.
The motherboard seems to be in good order, though I did see a red wire with a some black marking on it near the connection.
Voltage is good.
Not sure where to go from here.
Thank you for any responses.