Since today I have a problem with my CR10 V3. I have the filament running through my filament-sensor and the led in the sensor is on. And as long as I don't start a print everything looks fine. No "change filament" error message. But as soon as I start a print the printer goes into "pause print" mode and for a fraction of a second will show the "change filament" error and then goes back to pause print. Andevery few seconds the "change filament" error will pop up for a fraction of a second and then back to pause print. Only if I remove the filament the display will show "change filament" (as it shoud) continously. But if I put the filament back into the sensor, the whole thing start from the begining.
Posts made by Anubis81
CR-10 V3 "change filament" error with Filament in Sensor