@jonas Are you talking about the dog, cat and pig or whatever? Yes I have them.
ArcherTheArcher
@ArcherTheArcher
Best posts made by ArcherTheArcher
Latest posts made by ArcherTheArcher
-
RE: Stanard gcodes
-
RE: Ender 3 pro - 4.2.2 - BL touch upgrade issue
@admin thank you for the specific file.
i loaded the 1.4.1 file
since loading that file the display screen constantly swaps from the display screen to the menu without action
also, when going into menu options it will alternate from the change screen back to the previous menuis this expected on the new firmware?
-
Ender 3 pro - 4.2.2 - BL touch upgrade issue
I recently got the Ender 3 pro with the 4.2.2 board.
I also got the BL touchafter following the install instructions and then researching my issues I am stuck and hoping the community can point me in the right direction
I have tried both of the 4.2.2 firmware packets on the download site and neither seems to address my issue. If I used the "without" file, it will install and the BLtouch will respond. however I cannot home the Z axis.
If I use the "with" file it will install and the BLtouch will respond. I can adjust the Z axis, but when I tell it to auto home it seems to think the Z axis is much lower then the print bed. Also, there is a constant beep / buzzer going off.
14 Nov, 2020
4.2.2 Ender-3 pro 32bit Marlin2.0.1 BLtouch V1.3.1with adapter board.rar
14 Nov, 2020
4.2.2 Ender-3 pro 32bit Marlin2.0.1 BLtouch V1.1.2without adapter board.rarSince I have the 4.2.2 32bit board, I am not sure where to go from here.
-
RE: Firmware Mishap
Seems that I too am having this similar issue after installing my BL touch and trying to use either of these files
14 Nov, 2020
4.2.2 Ender-3 pro 32bit Marlin2.0.1 BLtouch V1.3.1with adapter board.rar
14 Nov, 2020
4.2.2 Ender-3 pro 32bit Marlin2.0.1 BLtouch V1.1.2without adapter board.rarIf I use the "adapter" version it seems like I have full function, but there is a constant beep
when I use the "w/out adapter" it will home, then got to position X162, Y117, Z10 and tell them to "home Z" but I cannot get it to adjust down. it will go UP. and I can move X and Y axis without issue.
I have the 4.2.2 board with the ARM2 STM32F103RET6 chip
I have renamed the firmware .bin file something new each time and i have done both quick and non-quick formats on my SDcard before loading the firmware file.
any help would be greatly appreciated to get my printer working again